1, Load featureThere is a screw rotates in the tube body to push the plastic material move ahead, the screw typewill increase the pressure to overcome the big resistance.Plastic extruder is constant torque load, it needs high output torque, and meantime the temperature on the site is always high and Read More

1, Load feature(1) During washing processing, the running frequency is around 10Hz.(2) Heavy load at low frequency.(3) Forward / reverse running are switched frequently.(4) Big surge current.(5) During spinning-dry processing, the running frequency is as high as 130Hz or higher than 130Hz.(6) It alw Read More

1, Features of traditonal system(1) The traditional system works at heavy load for long time, forward and reverse run frequently, the lifetime of the system is short;(2) High failure ratio.(3) Low efficiency, the power factor is less than 0.8.(4) The safety performance is bad. 2, Requests for freque Read More

1,Load Feature:(1) With big fluctuation. (2) Lots of dusts in the operation sites. 2:Requests For VFD:(1) Soft start the motor, reduce the surge current, protect the motor and conveyer.(2) Big output torque at low frequency, it should run smoothly during working.(3) Motor speed can be adjusted by ex Read More

1, Load feature(1) PID function is required.(2) There is a pressure sensor in the system.(3) In theory, if the running frequency is H1, then Energy Saving = 1-(H1/50)3 2, Requests for frequency inverters (VFD)(1) Soft start the motor, reduce the surge current.(2) PID control should be stable and acc Read More

1, Load featureCNC machine is a mechanical-electrical integrated system include mechanic, electric, hydraulic, pneumatic, microelectronics and information technology, it has the features of high accuracy, highly automated and highly flexible.2, Requests for inverters (VFD)(1) It can work normally Read More

1, Load featureCircular Knitting Machine is widely used in the textile industry, it’s usually started by external signal, speed iscontrolled by external analog signal.The running speed is high, start torque is high, and also the system always needs fast stop. 2, Requests for AC Drive (VFD)(1) Big ou Read More

1, Load feature(1) It is used to drive high speed motor, the maximum speed is about 24000RPM, correspond to 400Hz, the minimum speed isabout 2000RPM.(2) It needs high torque at low speed. 2, Requests for frequency inverters (VFD)(1) Wide range of operation frequency.(2) It needs multi-points V/f car Read More

PLCs are computer control systems with numerous inputs that allow you to monitor and control different final elements from one device. PLCs often have both digital and analog inputs that allow the user to connect either transmitters or switches, and must be programmed by the user to determine the en Read More